CVE-2019-16272

9.8 CRITICAL

📋 TL;DR

DTEN D5 and D7 video conferencing devices have factory settings that allow attackers to reflash firmware and enable Android Debug Bridge (ADB), providing full device control. This affects all DTEN D5 and D7 devices running firmware versions before 1.3.4. Attackers can exploit this to gain persistent access to the devices.

💻 Affected Systems

Products:
  • DTEN D5
  • DTEN D7
Versions: All versions before 1.3.4
Operating Systems: Android-based firmware
Default Config Vulnerable: ⚠️ Yes
Notes: All factory default configurations are vulnerable. Devices must be manually updated to secure versions.

📦 What is this software?

⚠️ Risk & Real-World Impact

🔴

Worst Case

Complete device compromise allowing firmware replacement, persistent backdoor installation, credential theft, and use as pivot point into corporate networks

🟠

Likely Case

Unauthorized access to device, installation of malware, eavesdropping on meetings, and data exfiltration

🟢

If Mitigated

Limited impact if devices are isolated from critical networks and monitored for unusual activity

🌐 Internet-Facing: HIGH - Devices often deployed in conference rooms with network connectivity, potentially exposed to internet
🏢 Internal Only: HIGH - Attackers with internal network access can exploit this vulnerability

🎯 Exploit Status

Public PoC: ⚠️ Yes
Weaponized: LIKELY
Unauthenticated Exploit: ⚠️ Yes
Complexity: LOW

Exploitation requires physical or network access to device. No authentication needed to access factory settings.

🛠️ Fix & Mitigation

✅ Official Fix

Patch Version: 1.3.4 and later

Vendor Advisory: https://www.dten.com/support/security-advisories

Restart Required: Yes

Instructions:

1. Access device settings menu
2. Navigate to System Update
3. Check for updates and install firmware version 1.3.4 or later
4. Reboot device after update completes

🔧 Temporary Workarounds

Network Segmentation

all

Isolate DTEN devices on separate VLAN with restricted network access

Physical Security Controls

all

Restrict physical access to devices and disable unused ports

🧯 If You Can't Patch

  • Disconnect devices from network when not in use for meetings
  • Implement strict network monitoring for unusual ADB traffic on port 5555

🔍 How to Verify

Check if Vulnerable:

Check firmware version in device settings. If version is below 1.3.4, device is vulnerable

Check Version:

Navigate to Settings > About Device > Firmware Version

Verify Fix Applied:

Confirm firmware version is 1.3.4 or higher in system settings

📡 Detection & Monitoring

Log Indicators:

  • Unexpected ADB connections
  • Factory reset events
  • Firmware update attempts from unknown sources

Network Indicators:

  • ADB traffic on port 5555
  • Unexpected firmware download traffic
  • Unusual outbound connections from DTEN devices

SIEM Query:

source_ip="DTEN_DEVICE_IP" AND (port=5555 OR event_type="factory_reset" OR protocol="adb")

🔗 References

📤 Share & Export